![]() ![]() I don't understand why the drawing doesn't update by default. ![]() Save and close the drawing, then re-open (this works most of the time)Ĭheck the drawing, and part file back into Vault, then check out again (this usually works)Īll of this seems like it should not have to happen. Toggle between the drawing sheets, try the Update All Sheets again (a co-worker mentioned this sometimes works) Click Update All Sheets, nothing happens.Īnd this is where I start try the following, and not necessarily in this order. Go back to the drawing, and the update is not reflected !!!!!ħ. Open the part referenced in the drawing via right-clicking on the part, then OpenĦ. This is a problem I run into frequently, and would like some help.Ģ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |